为了使自动混凝土搅拌机在运行中不出故障，在机器出车前就要进行检查。对于该如何检查，下面来简单讲讲吧。

In order to keep the automatic concrete mixer from failure during operation, the machine shall be checked before leaving the vehicle. For how to check, let's briefly talk about it.

细心检查及时发现排除故障。千万不能让车坏在路上，否则出现闷罐就麻烦了，混凝土一般停罐不能超过2个小时。点火之前要先检查机油、防冻液、润滑油等，发现不足时，应重新进行添加。

Check carefully and find and eliminate faults in time. Never let the car break down on the road, otherwise it will be troublesome for the tank to be stuffy. Generally, the tank of concrete can not be stopped for more than 2 hours. Check the engine oil, antifreeze, lubricating oil, etc. before ignition. If it is found to be insufficient, add it again.

车子启动后，再让罐子低速旋转，围绕着车检查轮胎气压，是否有漏气的胎，再用螺丝刀剔掉在胎缝里的石子，检查是否有铁钉之类扎在胎里！

After the car starts, let the jar rotate at a low speed, check the tire pressure around the car, check whether there is a leaking tire, and then remove the stones in the tire seam with a screwdriver to check whether there are iron nails or the like stuck in the tire!

再检查灯光，尤其是腰灯，务必保证照着轮胎边缘，工地会经常乱堆放钢筋之类的东西，而胎侧是薄弱的。用抹布擦干净两边的后视镜，窗户玻璃，工地路况复杂，光线不好，视线一定要保证。

Then check the light, especially the waist light, to ensure that it shines on the edge of the tire. The construction site will often pile up reinforcement and other things, and the sidewall is weak. Wipe the rear-view mirrors and window glass on both sides with a rag. The road conditions on the construction site are complex and the light is bad. The line of sight must be guaranteed first.

保证水箱里有足够的水，有减水剂。若料太干，放不出料的时候，减水剂就是救命稻草了，要不然闷罐可就麻烦了。

Ensure that there is enough water and water reducing agent in the water tank. If the material is too dry to discharge, the water reducing agent is a life-saving straw, otherwise it will be troublesome to stuffy the tank.

确认自动混凝土搅拌机处于停工状态。因为发动机启动时万一罐子处于高速旋转状态，瞬间的力会很大的，伤害减速机。

Confirm that the automatic concrete mixer is in shutdown state. Because when the engine is started, if the can is in the state of high-speed rotation, the instantaneous force will be great and damage the reducer.

另外，自动混凝土搅拌机是一种特殊材质的运用车辆，若是在平日运用的进程里没有清洗洁净，是很容易就出现了沾罐的状况的，所以我们要做好自动混凝土搅拌机的清洁工作。

In addition, the automatic concrete mixer is an application vehicle of special materials. If it is not cleaned in the process of daily use, it is easy to get stuck in the tank. Therefore, we should do a good job in the cleaning of the automatic concrete mixer.

此外自动混凝土搅拌机装料前，应先排净拌筒内残存的积水和杂物。在运输过程中要不停的转动，以防混凝土离析。搅拌车到达工地和卸料之前，应先使拌筒全速以14—18转/分转动1—2分钟，然后再进行反转卸料。反转之前，应使搅拌筒停稳，然后再开启反转。

In addition, before loading the automatic concrete mixer, the residual ponding and sundries in the mixing drum shall be drained first. Keep rotating during transportation to prevent concrete segregation. Before the mixer truck arrives at the construction site and unloading, first rotate the mixing drum at full speed at 14-18 rpm for 1-2 minutes, and then reverse unloading. Before reversing, the mixing drum shall be stopped stably, and then the reversing shall be started.

自动混凝土搅拌机出车前的必做检查工作便是相关内容了，如果您想知道更多就来关注我们的网站www.zkhntjbc.com吧！

The necessary inspection before the automatic concrete mixer is the relevant content. If you want to know more, please pay attention to our website www.zkhntjbc.com Com!