When using the concrete mixer, pay attention to maintenance and timely cleaning to avoid delaying production for various reasons. Zhongke Jufeng concrete mixer is a construction machinery manufacturing enterprise integrating R & D, manufacturing and sales. Both concrete mixing plant equipment and concrete mixer equipment are highly praised by users. It is a reliable manufacturer. Welcome customers to consult and order or visit our factory..

混凝土搅拌机是生产混凝土的主要设备，混凝土搅拌机是把水泥、砂石骨料和水混合并拌制成混凝土混合料的机械。在使用过程中要注意日常保养，如果不注意保养，可能会出现抱轴的情况，混凝土搅拌机出现抱轴的原因也是有多种的。

Concrete mixer is the main equipment for producing concrete. Concrete mixer is a machine that mixes cement, gravel aggregate and water into concrete mixture. Pay attention to daily maintenance during use. If you don't pay attention to maintenance, axle holding may occur. There are many reasons for axle holding of concrete mixer.

1、可能是原料投料位置问题。搅拌混凝土所用的物料主要是砂石骨料、水泥、粉煤灰、水喝外加剂等。原料水泥若包裹砂石遇水结块，如果搅拌不充分就容易粘在搅拌轴上，若水泥进料口位置方向不合理，使搅拌轴不能快速充分搅拌，就容易形成抱轴现象。

1. It may be the feeding position of raw materials. The materials used for mixing concrete are mainly sand and gravel aggregate, cement, fly ash, water and drinking admixture, etc. If the wrapped sand and gravel of the raw cement agglomerates with water, it is easy to stick to the mixing shaft if it is not fully stirred. If the position and direction of the cement feed inlet is unreasonable, the mixing shaft cannot be quickly and fully stirred, and it is easy to form the phenomenon of shaft holding.

2、混凝土搅拌机进水管与冲水位置原因。冲水点位置和冲洗方向不正确的话，又或者是冲水压力过低，导致水在进入主机内部后，不能将暂时粘结在轴上的混凝土冲洗掉，则时间久了就容易形成抱轴。

2. Causes of water inlet pipe and flushing position of concrete mixer. If the position and direction of the flushing point are incorrect, or the flushing pressure is too low, so that the water cannot flush the concrete temporarily bonded to the shaft after entering the main engine, it is easy to form the shaft holding after a long time.

3、在结构生产之后没有及时对混凝土搅拌机内部进行清洗，或清洗的不干净，导致搅拌轴表面仍有残留的混凝土，干燥后凝固在搅拌轴上，如果长期如此则非常容易产生抱轴现象。

3. After the production of the structure, the interior of the concrete mixer is not cleaned in time, or the cleaning is not clean, resulting in residual concrete on the surface of the mixing shaft, which is solidified on the mixing shaft after drying. If this is the case for a long time, it is very easy to produce shaft holding phenomenon.